Found the unit had no error codes. Also the unit is operating perfectly at the moment. I do recommend the customer clean there condenser for better operation and so the compressor doesnt overheat. Only charging trip and diagnostic.

Found the new cam assembly that was just replaced in January has warped and failed cause a noise during wash. I took photos of the old one and the new one as well. Please bill out for the same part being replaced. All functions restored after repair. Job completed.

"After replacing the compressor, drier and inverter I then vacuumed out the system. The unit gave no indication of a leak so I charged the unit to 56 grams or r600a. The unit started cooling. It will take 24 to 48 hours for the temps to normalize. Job completed."

I replaced the wire harness from the main control to the heater and took photos of the process during repair. I then ran step 8 in diagnostics and the unit is no longer giving a f4e1. Step 8 test the heater. All functions now restored and working. Job completed.

Found the unit making a grinding noise in agitation. I gained access to the transmission and found the shield covered in oil and the parts attached to the gearcase. Will need to replace all parts saturated in oil as well as the transmission. Will order all parts needed and I took photos of all the parts affected. The suspension test failed so will replace those on return. ; ordrng 1 WP389140 (Block drive) and 1 WP21366 (Nut) and 1 285565 (Agitator) and 1 W10772621 (Screw) and 1 W11454741 (Gearcase) and 1 W10890624 (Motor drive) and 1 W11239857 (Belt) and 1 W11481722 (Actuator) and 1 W11428524 (Capacitor) and 1 WPW10427633 (Shield) and 1 W10721967 (Cam)