"The door assembly was replaced due to old one not closing properly with new door after replacement now closes and opens correctly with no further issues, job completed."

"F0/E5 error code, off balance issue. Told Cx about over loading the washer said since theres a lot of ppl on house doesnt know who over loads it but will put note to make sure they understand, job completed."

"Found the unit, not cooling, unit not have refrigerant, replaced service valve, charge nitrogen and verify leak in low side evaporator, repair leak, make a vacuum and charge refrigerant 40g R600a check, compressor, condenser and evaporator fan motors unit work normal ; used 1 W11506635 ( Service valve) from stock"

Install the new door on the unit. Retest the unit and unit is working properly. Job complete

Cx states that unit is not working properly After running diagnostic check get error code F2E2F1E2Reboot main board tested all components Unit working properly as designed Cx has broken lid lock and glued Physical damage more than 30 days not covered Job is completed