"In warranty. Replaced drain pump and rod and spring assembly. Ran drain and spin cycle. The washer completed spin cycle, but did not drain. Shorted pump caused a short in control board main harness. GE recommended to the parts at same time. Techline sr#219050330.; ordrng 1 WH22X33178 (MAIN CONTROL BOARD W/INSTRUCTIONS) and 1 WH08X33737 (MAIN HARNESS) and 1 WH23X28418 (Drain pump)"

"Customer reports, IT SHOWS A CANCEL MESSAGE ON SCREEN. IT POWERS ON BUT WONT START. In warranty. In diagnostics found f31x20- out of balance, f26x29 out of balance and f18x1- drain pump fault. Square trade will deliver part to customer.; ordrng 1 WH03X32158 (SPEED SENSOR) and 1 WH03X33317 (MOTOR PULLEY & NUT) and 4 WH01X33277 (ROD AND SPRING 5.0)s and 1 WH23X28418 (PUMP DRAIN ASM)"

"UNDER WARRANTY- CX stated, WASHER NOT SPINNING AND RINSING, REALLY BANGING AND SQUEALING NOISE.Unit has a worn out suspension, replaced it, calibrated, tested, unit working to spec. Job completed."

"Customer is very concerned that her oven is overheating and is causing the sides . . .Set bake Temps at 350 unit cycled repetitive times, without a problem. The heating of the body, door glass and control panel is normal, flu box is sitting in its place, ventilating as designed. Customer not happy with how warm the unit gets. Will call tech line to report and advise tomorrow, already closed today . ; schdld next appmnt for 7/11 FRI AM"

Dryer not operating ( very loud ). Drum rear panel screws broke off. Need drum assembly.; ordrng 1 WE21X23869 (DRUM ASM)