"Upon arrival found the water flow low on the dispenser, check the unit and found the problem is with the water valve connector it loose causing the solenoid no to open all the way. Readjust and retest now unit is working properly. Job complete"

Upon arrival found unit with drum falls down in the front right corner. Check the unit and found the rod suspension hanging form the wires harness of the latch. Check the unit and found the bushing suspension totally broken causing the failure. Replace the suspension on the unit because all the rods was already damaged. Retest the unit and now is working properly. Job complete

"Install the new interlock switches on the unit. Retest the uni, and now is working properly. Job complete."

"Upon arrival according with customer microwave is no heating. Check the unit with one cup of water for minute, and initial temperature was 64.5 and no change after the minute. Check the unit and notice when you push the door against the unit, the microwave comes back to work normally again. This unit has a problem with the interlock switches. ; ordrng 1 A23242801 (Interlock left) and 1 A23243301 (Interlock right)"

"Upon arrival found unit no producing any ice, check the unit and temperatures are correct on both compartments. Check the unit on test mode 56 and as an error code E2, this about motor no finding the home position. Replace the ice maker on the unit, and found the unit has a reverse osmosis on the back for filtration. Inform the customer this is going to affect the ice production, because the low pressure water as a the output. Test the water dispenser and it takes 18 seconds for 8 oz, this test without filter for the unit. Inform the customer the proper pressure need to be at least 50 psi. Retest the unit and now unit doesnt have any more error code and is cycling correctly. Job complete"