Visual and physical inspection was meticulously conducted and found a few issues and consumer was quoted on most important ones vital to the functionally of the fridge and she has declined.; ordrng 1 W10815668 (Door asm)

"Visual and physical inspection plus a functional test was conducted and unit Otis presetting the following symptoms, long fill, very long draining cycle, plus through diagnostics found an F8 E1 error that references long fill. The following is recommended for replacement. Drain pump, pressure sensor, and water valves.; ordrng 1 W11125159 (Pressure sensor) and 1 W11036930 (Double water inlet) and 1 W11036928 (Water inlet single) and 1 W11319789 (Drain pump)"

"Visual and physical inspection plus a Rinse n Spin cycle were conducted to observe unit behavior, and found a restricted water flow and an out of center basket. Replacing inlets and suspension recommended.; ordrng 1 WPLW11168740 (Cold inlet) and 1 WPLW11168743 (Hot inlet) and 1 W11130362 (Suspension)"

"A new appliance manager has been installed and at the testing point, I am still getting the same error code (F2 E1).Since all the check points have been covered, I am suspecting a DOA UI panel, and to play it safe, I would like to order the mini power board. ; O-emld tckt"

Not the same issue. The times has become very difficult to turn hence the knob fitting cracked and its unable to turn timers shaft anymore. Replacing Timer and knob recommended.; ordrng 1 MGD4500MW1 (Timer) and 1 W11328381 (Knob)