Installed filter kit. Reassembled and re-tested. Fill tube shouldnt have any more freezing issues according to tech line. Job complete

Upon arrival the unit would not power on. I unplug the unit for several seconds and plugged it back in. Was able to put it in the diagnostic mode after this. Checked air codes and found F1E1 main control fault. This is a new error code as I cleared them last visit. Troubleshooting guide suggests the board and shifter assembly could be causing this issue. Ordering both for return.; ordrng 1 W11116592 (Control) and 1 W10913953 (Shifter)

"Internal drain hose was not securely camped to drain pump. It was allowing a small mount of water to leak at end of cycle. Refastened hose and clamp and ran through diagnostic cycle. Found no more leaks after making adjustments. Also, I zip tied drain hose to drain pipe. It was barely hanging inside and at risk of popping out and draining on floor. Customer shouldnt have any more issues with leaks."

Unit has several bad bearings on the rollers. Need to replace them all. Ordering for roller kits for return visit. Also going to change the idler arm assembly.; ordrng 4 5304523155 (Roller kit)s

"Changed sensor and ran a preheat cycle. With new sensor, my average temp was 15° above set temp. I made adjustments and retested. Unit is now staying within set temperature range. Customer is going to give it a test. She will let us know if any further adjustments are needed."