"Left Door receiver was slightly defective. Door hinge could not sit down into its slot. I used a metal file to file away the excess metal of the receiver. After this, the hinge was able to seat properly. Door is now sitting flush, and aligned."

Installed new by metal harness assembly. Customer will monitor refrigerator over the next month and let us know if the issue persists.

"Installed all new parts. Raised feet, so that unit has less of a chance of touching ground while washing bigger loads."

Found actuator slipped out of the splutch. Replaced actuator with the truck stock W10913953 and ran cycle. Unit passed all tests and is operating as designed.; used 1 W10913953 (Actuator) from stock

JB out 10/27/22. Installed replacement MAINTOP ( user interface) and Main Wire Harness as instructed by GE T.A.G. Reassembled and tested operation. Unit powers up and with correct cooling vessel on burner does not heat. After 3-7 seconds unit acts as if the is no cooking vessel detected on the burner and shuts off. Installed GE Smart H Q diagnostic device. Recorded stored F codes F61 and F62: Cannot communicate with induction module. Contacted GE T.A.G. and spoke with Bob. Bob review all service visit notes and classified the unit as non repairable then issued Case#08575818. Customer will contact GE for resolution.